MGP WRM2 Manual de usuario descargar pdf (Pagina 19)

15-00043

Revision 3

September 2005

The publication, translation or reproduction, either party or wholly, of this document are not allowed without our written consent. 19

If the base has been optionally configured with 2 radios, in this position Radio 1 serial data output

is connected to the Radio-2 serial input in order for Radio-2 to transmit any RF data received by

Radio-1 at once. This configuration is used for a streaming repeater mode. The network adaptor

and RS-232 lines are connected to monitor Radio 1 data for local monitoring.

Repeaters are factory set for use in an area where only one

repeater is needed. If two or more

repeaters are needed they can be within RF range of each other, the DT addressing is a must:

• MESH Repeater Masking configuration addressing of two or more units.

- Repeater #1 = MK = ‘FFFF’ DT = ‘NNNN’

- Repeater #2 = MK = ‘FFFF’ DT = ‘NNNN’

- Repeater #3 = MK = ‘FFFF’ DT = ‘NNNN’

- Repeater #4 = MK = ‘FFFF’ DT = ‘NNNN’

Note: refer to Section 2.3 for Repeater addressing.

• Base, PAM-TRX, DRM-1, and EXT station/s needs DT and MK address command set so all

repeaters are seen by the base stations and PAM- TX (Broadcast mode)

- Base Station #1 = DT = ‘FFFF’ MK = ‘0’

- Base Station #2 = DT = ‘FFFF’ MK = ‘0’

- Base Station #3 = DT = ‘FFFF’ MK = ‘0’

Figure 13 below depicts a field example of a Repeater Configuration:

Figure 13: Base, Repeater & Transmitter Signal Routing (example)

2.2.4 Batteries

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Sin comentarios

MGP WRM2 Manual de usuario Pagina 19