MGP WRM2 Especificaciones descargar pdf (Pagina 15)

TelePole WR/ Operating & Maintenance Manual Page 15

Following is the operating procedure.

4.1.1. A short press on the B.CODE push-button turns the bar-code reader on. Three short

beeps will be sounded. The bAr. LCDs are displayed.

4.1.2. If the bar-code reading is successful, the Go. LCDs will be displayed.

4.1.3. To save the instrument data (ID, time, date, value, unit, comments) perform a short

press on the STORE push-button.

4.1.4. After the saving operation, the amount of available memory space remaining is

displayed.

4.1.5. To load data from the TelePole to the survey mapping software, connect the RS232 of

the PC to COM-1 on the TelePole rear panel by a special communication cable (supplied

with the software system). Downloading data from the TelePole to the PC clears the

instrument’s memory. TelePole can store up-to 380 readings (or 1550 optional with

extended memory).

Warning: To purposely clear data from the TelePole’s memory press the B.CODE push-

button for 10 seconds, the current available memory space is displayed for an additional

ten seconds. An additional press on the B.CODE push-button within the ten seconds erases

the data. The instrument indicates it by four audible beeps and 380 m, the new available

memory space is displayed.

4.2. WRM Communication

The WRM transmitter is connected to the serial port COM-2 located in the instrument’s rear

side via a standard telephone cable. The additional operations like transfer of data, are

performed automatically. The WRM communication protocol includes accumulated dose

data. Note: The TelePole does not measure accumulated dose, therefore instead of

transmitting the accumulated dose value, it transmits the digits 888888.8.

4.3. WRM2 Communication

The WRM2 optional kit(WR2-A??) is connected via two screws on the meter box and is

level is defaulted 4 seconds and can be changed using the Meter View software with the

communication cable designed for the TelePole and the Ram Ion and the baud rate to the

Telepole when using the WRM2 radio is set to 19,200 BPS. The WRM2 kit is available to

older instruments built 2006 or later and require new firmware and two wired jumpers

installed. Instruments built in 2007 or greater are pre-configured for the WRM2 Telepole

kit. Note: The TelePole does not measure accumulated dose, therefore instead of

transmitting the accumulated dose value, it transmits the digits 888888.8.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Sin comentarios

MGP WRM2 Especificaciones Pagina 15