MGP WRM2 Especificaciones descargar pdf (Pagina 46)

TelePole WR/ Operating & Maintenance Manual Page 46

9.2. Preparation for Use

Note: See the telescopic pole construction scheme for reference.

NOTE: The manufacturer recommends that the end user/owner to perform periodic

inspections of the telescopic pole, collars, and clutches to ensure proper operational

use and safety.

9.2.1. Check the condition of the segments, collars, and clutches (under collars) as follows: Hold

the telescopic pole with both hands horizontally. Wear the carrying strap (15) over the head

and on the shoulder, one hand holding the pole and the other hand free to adjust the strap to

the optimal length. See Figure 7-1.

Figure 7-1. Telescopic pole holding

9.2.2. Check the segments' fastening/collar nuts (8: a, b, c) by turning them slightly, to make

sure there are no disturbances or wore clutches.

9.2.3. Check the pole segments (9, 10, 11, 12) by extending them all the way out, following the

proceeding steps:

9.2.4. Ensure the three fastening nuts (8: a, b, c) are locked.

9.2.5. Loosen nut (8c) by turning it counter-clockwise (looking from the meter side).

9.2.6. Pull segment (12) all the way out.

9.2.7. Tighten nut (8c).

9.2.8. Loosen nut (8b).

9.2.9. Pull segment (11) all the way out.

9.2.10. Tighten the middle nut (8b).

9.2.11. Loosen nut (8a).

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 57 58

Sin comentarios

MGP WRM2 Especificaciones Pagina 46