MGP WRM2 Especificaciones descargar pdf (Pagina 49)

TelePole WR/ Operating & Maintenance Manual Page 49

Figure 7-3. Meter disassembly

9.4.2. Loosen the four NC 6-60 Philips screws fastening the meter holder (4) to the meter.

9.4.3. The meter and holder are now detached from the telescopic pole. See Figure 7-3.

9.5. Meter Holder Assembly (4)

9.5.1. Position the meter (5) on a flat and clean surface with the display facing down.

9.5.2. Position the telescopic pole on the meter rear cover.

9.5.3. Position the meter holder (4) on the meter (5) while the cable groove is facing the telephone

socket side.

9.5.4. Ensure the cable goes through the inside space created between the meter holder and the

meter rear cover.

9.5.5. Attach the meter holder (4) to the heat shrinkable tube (3) and tighten the four screws.

9.6. Detector Assembly (14)

9.6.1. Connect the cable to the detector. Insert the detector (14) back into the pole’s end.

9.6.2. Tighten the three NC 4-40 x 3/8 Philips flat screws located on the detector bottom part (14),

use lock tight material to secure the screws.

9.7. Pole Segments Assembly

9.7.1. Insert the segments (9, 10, 11, 12) one into the other according to their diameter size, from

the largest to the smallest one, while the threads are facing forward in the detector direction.

9.7.2. Insert plastic rings into the two biggest fastening nuts (8a, 8b).

9.7.3. Screw the two fastening nuts (8a, 8b) on the segments (9, 10), in order of their size (first

the bigger nut 8a), and then fasten them.

9.7.4. Insert the smallest plastic ring on the last segment (12), push the ring backwards, next to the

thread of segment (11).

9.7.5. Insert the third nut (8c) and screw it on segment (11).

9.8. Pole Segments Disassembly

9.8.1. Perform the steps in section 7.7 in the reverse order.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 57 58

Sin comentarios

MGP WRM2 Especificaciones Pagina 49